Skip to main content

How To Change A Cmos Battery

NETWORK TECH WORLD First the safety rules

The inside of a computer is a bad place full of electricity and sharp edges.
On the electricity side always when working on you computer make sure that it’s still plugged in to the power socket and the power is turned off, this is to ensure that any static
From you is discharged through the earth. The inside of most computer cases are unfinished metal and has very sharp edges so be careful.

The first signs of a battery failing are:-

1) your clock starts running slowly
2) when you boot (start) your computer it has a problem finding your hardware (no hard drive, no cd rom)

To change the battery you need the following tools

1) a X-point screwdriver
2) an anti-static strap(optional)
3) a new battery (seems logical)

Then unplug all the cables from the back of the computer as you remove them make a note where they came from. (So when you finished you can put them back)

Move the computer somewhere where you can work on it with ease

Remove the cover by locating the screws around the outer edge (back) of the computer
Some computer cases only require you to remove 2 screws on one side then a panel can be removed allowing you access to the computers insides, others you must remove 6 screws and remove the whole case by sliding it to the rear and lifting it off.

Now make sure that you read the safety instructions about static.
Look inside you will see a round silver thing that looks about the size of a 10p piece (quarter). This is the battery itself, carefully lift the retaining clip and slide the battery out. That’s it removed now go to your local computer retailer, electrical retailer (Tandy/Radio shack) taking the old battery with you and get a new battery.

Back to your computer insert the new battery by lifting the clip and sliding the battery in.

Reinstall your case and plug all the cables back (you did remember to label them didn’t you)

Now for the fun part.

You will now need to go into you bios….

Right the bios is the god of your computer.

To access it, when your computer first starts you will see a black screen with white text.

If you look carefully you will see a line that says something like "press del for setup" or some other key (F2 or ESC or tab) this will take you to god's house where you can make lots of changes to the way your machine works.

It is also the place where you can make your nice computer in to a rather expensive door stop so be careful and don’t go playing with anything.

You will now be presented with a blue screen with a lot of options on it,
The one we want is load optimised/default settings.

Press the F10 key and type y the computer should now reboot.

If every thing went well then your computer will now be up and running.



Shizers way: Keep computer running. Lay it on it's side and remove side cover to expose MoBo. Take any thin object, "small screwdriver, knife point, wood shiskabob skewer. Pull back the battery retaining clip. Toss the old battery in the junk recepticle, unless you belong to greenpeace and want to save the earth. Install the new battery. No need to reset bios becasue the compter supplies voltage to the cmos while it is running. Reset or resync clock with internet. Done!

Comments

Post a Comment

Popular posts from this blog

What is network

NETWORK TECH WORLD What is network  A network is a group of devices, such as computers, servers, and printers, that are connected together and able to communicate with each other. Networks can be classified based on their size and scope, such as a local area network (LAN), which is a network that is confined to a small area, such as a single building or campus, or a wide area network (WAN), which is a network that spans a large geographical area, such as a city or a country. Networks can also be classified based on their communication protocols, such as the Internet, which is a global network that uses the Internet Protocol (IP) to connect devices around the world.
Post a Comment
Read more

Network Devices

NETWORK TECH WORLD A network device is a hardware device that helps to connect a computer or other devices to a network. There are several types of network devices, including: Routers: These devices route data packets between different networks. Switches: These devices allow multiple devices on a network to communicate with each other by forwarding data packets to the intended recipient. Hubs: These devices are similar to switches, but they do not filter the data packets based on the destination. Instead, they broadcast the data packets to all devices connected to the hub. Bridges: These devices connect two different networks and allow data packets to be transmitted between them. Modems: These devices allow computers to connect to the internet by converting data into a format that can be transmitted over a phone line or cable connection. Firewalls: These devices protect a network by blocking unauthorized access and monitoring traffic for any malicious activity. These are just a few exa...
Post a Comment
Read more

How to Hack Computer

NETWORK TECH WORLD  How to Hack Someone's Computer As the digital world becomes more and more complex, the need for deliberate, thorough security grows. Yes, we know, you’ve got everything “password protected.” And yes, not every hacker is like the guys in the movies who are able to keyboard their way through complicated layers of encrypted, password-protected security faster than a gamer boots up a new version of Call of Duty. In the real world it’s a lot easier than that. And no, this isn’t actually a tutorial about how to break into someone’s computer or smart phone or tablet. Just an observation of sorts. A caution to our loyal readers, if you like. The Brand Keys 2012 Customer Loyalty Engagement Index reveals that consumers choose laptop computers on the basis of anything but security. Instead, consumers tend to select on the basis of factors like innovative design and brand reputation. This doesn’t mean that security isn’t important, but that it does mean that it’s...
Post a Comment
Read more